Table of Contents
Advertisement
Front Panel LED Definition
LED
PWR
DSL
LAN1-4
2.1.3 Rear Panel of VC-230
The rear panel provides the physical connectors connected to the power adapter and any other network device.
Figure 2-2
shows the rear panel of the VC-230.
Rear Panel Port and Button Definition
Connector
POWER
Power connector with 12V DC 1 A
RESET
Press more than 3 seconds for reset to factory default setting.
Router is successfully connected to a device through the corresponding port (1, 2, 3, or 4). If
LAN (1-4)
the LED light of LNK/ACT is flashing, the Router is actively sending or receiving data over that
port.
PHONE
Built-in splitter for POTS connection.
The RJ-11 connector allows data communication between the router and the VDSL2 network
VDSL2
through a twisted-pair phone wire
State
ON
When the router is powered on, and in ready state.
OFF
When the router is powered off.
Router is trying to establish a VDSL2 connection to VDSL2 device or
Flashing
telecom's network.
ON
The VDSL2 is connected successfully.
Flashing
Data is being transmitted or received via the corresponding LAN port.
ON
The port is up.
Table 2-1 The LED indication of VC-230
Figure 2-2 VC-230 Rear Panel
User Manual of VC-230/230N
Description
Description
16
Advertisement
Table of Contents
