Table of Contents
Advertisement
User Manual of VC-230/230N
5.1 Operation Mode
The VC-230 supports two operation modes – Bridge and Gateway; the VC-230N supports three operation
modes – Bridge, Gateway and WISP. Currently, the default setting is Gateway mode.
Please note that Bridge mode and Gateway mode cannot be used simultaneously.
For Bridge mode, all interfaces are bridged into a single bridge interface.
For Gateway mode, the VDSL port is treated as WAN port. The other interfaces are bridged together and are
treated as LAN ports.
For WISP Mode, all the Ethernet ports (including VDSL2) are bridged together and the wireless interface of
this router will come to WAN port for connecting to an ISP's Access Point as Internet connection. The NAT is
enabled and PCs in Ethernet ports share the same IP to ISP through wireless LAN. The connection type can
be set up on WAN page by using PPPoE, DHCP client, PPTP/L2TP client or static IP.
If you select Bridge mode and WAN configuration in Internet Settings that are not
available, firewall functions on the left page are not available, either.
After finishing the settings, click Apply to save the settings and enable the new configuration to take effect.
Click Cancel to close without saving.
39
Advertisement
Table of Contents
