When this is set, you receive an e-mail notification if a problem or warning occurs in the projector. For information on the contents of the sent e-mail,

p.110

Sub Menu

Mail Notification

SMTP Server

Port Number

Email Address 1/Email

Address 2/Email Address 3

Setting a Notification Event

You can set whether or not (On/Off) to be notified by e-mail.

You can input the IP address

for the SMTP server for the projector.

You can input a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used.

127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)

You can input the port number for the SMTP server. The default value is 25. You can input numbers between 1 to 65535.

You can input the e-mail address of the destination to send the notification e-mail to. You can register up to three destinations. You can enter up to

64 single-byte alphanumeric characters for the e-mail addresses. You cannot enter more than 32 characters on the configuration menu. When

setting from Web Control, you can enter more than 32 characters.

You can select the problems or warnings to be notified about by e-mail. When the selected problem or warning occurs in the projector, an e-mail is

sent to the specified Email Address notifying that a problem or warning has occurred. You can select multiple items from the displayed items.

Function

Table of Contents