Charge Your Phone Wirelessly - Kyocera Hydro Vibe User Manual

Plug the smaller end of the USB cable into the charger/accessory jack on the bottom of your
l
phone.
Plug the other end of the USB cable into the charger, and then plug the charger into an
l
electrical outlet.
Note: Your phone's battery should have enough charge for the phone to turn on and find a signal,
run the setup application, set up voicemail, and make a call. You should fully charge the battery as
soon as possible.
3. Press and hold the Power Button to turn the phone on.
If your phone is activated, it will turn on, search for service, and begin the setup process.
l
If your phone is not yet activated, see
l

Charge Your Phone Wirelessly

Your phone supports the PMA standard via a wireless charging accessory (sold separately). Follow
the steps below to charge your phone wirelessly.
Important: Use only wireless chargers that are approved by the manufacturer of your phone.
1. Place your phone on the wireless charger, ensuring that the charging area of your phone
touches the charging area of your wireless charger.
2. When you see "Wireless charging" on the status bar, slide down the status bar to display the
Notifications panel, and then touch Wireless charging.
Get Started
Activate Your Phone for more information.
3