Registering Repeaters - Uniden BLUETOOTH XDECT R035BT Owner's Manual

In about 30 seconds, the handset display should say
. Press
Complete
Each of these bases can support up to two DRX402 Ultra-

Range chargers, including any that were supplied with
If...
your phone.
- you don't hear a dial tone
Usually, you can't tell when a handset switches between

- the display says Registration Failed
the base and the charger in the middle of a call, but
sometimes, you might notice a brief pause in your
conversation.
If you are having trouble with a repeater or if you want to replace one,

Registering Repeaters

you need to register the repeater to the base.
Registering the Ultra-Range charger
TIP: Connect the repeater close to the base for easy access to the
Registering the Ultra-Range charger is a separate
necessary keys and indicators. Locate the repeater in the desired
process from registering the handset. You can use
position after registration is complete.
the charger even if the handset is not registered.
1. On the base, press and hold
1. On the base, open the menu and select Register Handset.
when the phone is in
standby.
2. On the bottom of the Ultra-
fIND
Range charger, press and
2. On the bottom of the repeater
hold the registration button
you want to register, press and
until the
hold the registration button
blink (about 2 seconds).
until the
3. Release the button and wait
rapidly.
for the
LINk
and steady (this can take
about 90 seconds).
3. In about 90 seconds, the
repeater will turn on. The repeater has been
registered to the base.
If the LINK light doesn't turn on, try these steps
again.
Only register one charger at a time. If more than one

charger is in registration mode at the same time, they can
interfere with each other.
If you want to use the Ultra-Range charger with a different

base, just register the charger to the new base. The
TaLk/fLash
light starts to
LINk
light blinks
light to turn on
LINk
If the
disconnect the charger's AC adapter.
Wait about ten seconds, then try these
steps again.
Some important things to remember:
and make sure you get a dial tone.
Try...
Making sure the handset is
fully charged, then starting
over at step 1.
LINK light on the
light doesn't turn on,
LINk
Registration
37