Installing A Line Filter Or Dsl Filter - Uniden BLUETOOTH XDECT R035BT Owner's Manual

If static is on 1 handset or in
1 location:
Check nearby for one of
-
the common interference
sources.
Try moving the handset away
-
from a suspected source, or
try moving the suspected
source so it's not between the
handset and the base.
There is always more noise at
-
the edges of the base's range.
Out of Range
If an
displays, try moving closer to
the base.
Sometimes, broadband Internet services that use the telephone line

Installing a line filter or DSL filter

can interfere with phones. One of these services−DSL−often causes
static on telephones. A DSL filter or telephone line filter usually solves
this problem. The technician who installed your DSL service might
have left some filters for you; if not, call your DSL provider or look in
any electronics store.
Plug the DSL filter into the telephone wall jack and plug your phone's
base into the filter. Make a test call to make sure the noise is gone.
Do you use a T-Coil hearing aid?
If you have a hearing aid equipped with a telecoil (T-coil) feature, the
-
interaction between the hearing aid and digital cordless phones can
cause noise in the handset. If you have a T-coil hearing aid and you have
problems with noise on the line, try turning on
menu. Select
Using T-coil mode can shorten the handset's talk time; make sure to
-
watch the battery status and keep the battery charged.
34
message
Handset Setup,
If static is on all handsets or in all
locations:
Check near the base for the source
-
of interference.
Try moving the base away from a
-
suspected source, or turn off the
source if possible.
If the base has an adjustable
-
antenna, try raising the antenna so it
stands straight up.
If you have any service that uses the
-
phone line, you might need a filter
(see below).
T-coil
then select
T-coil
mode. Open the
.