Setting Up The Server - Fujitsu PRIMERGY TX100 S3 Core Edition Operating Manual

5.2

Setting up the server

Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see
Ê Set up the server.
V
CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê Wire the server. Follow the instructions in sections
the server" on page 40
page 42.
Ê Connect the server to the mains (see section
mains" on page
TX100 S3 Core Edition
section "Unpacking the
and "Notes on connecting / disconnecting cables" on
41).
Operating Manual
Hardware installation
server").
"Connecting devices to
"Connecting the server to the
39