Setting Up The Server - Fujitsu PRIMERGY TX1320 M1 Operating Manual

5.2

Setting up the server

Ê Set up the server.
I
Note that the server may be operated in the vertical (see section
"Positioning the server vertically" on page
(see section
V
CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the system.
Ê Wire the server. Follow the instructions in sections
the server" on page 53
page 56.
Ê Connect the server to the mains (see section
mains" on page
TX1320 M1
"Positioning the server horizontally" on page
and "Notes on connecting/disconnecting cables" on
54).
Operating Manual
Hardware installation
48) or horizontal position
"Connecting devices to
"Connecting the server to the
51).
47