MAINTENANCE
Replacing Casters/Forks
Replacing Rear Casters
NOTE: For this procedure, refer to FIGURE 7.7
1. Place the lift on its side.
2. Remove the bolt and locknut that
secure the existing rear caster to the
fork.
NOTE: The bushing will be loose and may fall
out of the caster.
NOTE: Existing bushing will be reused.
Examine and replace if worn.
3. Install the new/existing bushing into
the new rear caster.
4. Line up the mounting holes in the new
rear caster and the fork.
5. Install the bolt through the fork and
new rear caster and tighten securely
with the locknut.
Replacing Front Casters
NOTE: For this procedure, refer to FIGURE 7.8.
1. Place the lift on its side.
2. Remove the bolt and locknut that secure the existing front caster assembly to the fork.
NOTE: The front caster assembly consists of two casters and a washer in between.
NOTE: The washer will fall out from between
the two casters.
NOTE: Washer will be reused. Examine and
replace if worn.
3. Position the new/existing washer
between the two new casters.
4. Line up the mounting holes in the new
front caster assembly and the fork.
5. Install the bolt through the fork and the
new front caster assembly and tighten
securely with the locknut.
Stand Up Lift Model RPS350-2
Locknut
Rear Caster
Bushing
FIGURE 7.7 Replacing Rear Casters
Locknut
Washer
Front Casters
FIGURE 7.8 Replacing Front Casters
36
Base
Fork
Bolt
Base
Fork
Bolt
Part No. 1145811