Usage; Assembling The Rollator; Operating Position; Folding The Rollator - Invacare Banjo P452E/3 User Manual

3 USAGE

3.1 Assembling the Rollator

The locking lever and washer are installed on the outside of the

frame tubes.
Before the rollator is assembled remove the plastic crossbar between
the rear wheels and any plastic caps in the side tubes.

3.2 Operating Position

1. Install the locking lever (A) with the bolt (B). Ensure that the head
of the bolt slots into the recess on the fitting.
2. Insert the handle tubes into the side uprights and tighten the lock-
ing levers. These MUST be pointing downwards during use.
3. Press the rollator downwards to the safety latch (C), positioned
to the right underneath the seat, lock.
WARNING:
ALWAYS check that the safety latch is in locked position.

3.3 Folding the Rollator

4. Release the safety latch (D).
5. Lift the cross tube under the seat upwards (E). Be careful of the risk
of pinching fingers between the rear and front frame.
3-5)
1)
C
B
A
2)
E
D

3.4 Adjusting the handle height

Undo the locking levers and adjust the handles to a suitable height.
Tighten the locking levers which should then be adjusted so that they
point downwards. (The locking levers can be freely turned by first
pulling them outwards). The handles should normally be positioned
at wrist height.
WARNING: Risk of falling
The handlebars MUST point directly backwards when using
the rollator. Under no circumstances should they be angled
outwards, otherwise the lateral stability of the rollator is
reduced.
The handles MUST NEVER be set above their highest position,
indicated by the knurling on the tubes (see picture A). Handles
should be set to the same height on either side.
23
A)