Table of Contents
Advertisement
Channelized STM1 IQ PIC
Software release
Description
Hardware features
Software features
Cables and connectors
LEDs
JUNOS 8.0R2 and later (Type 1)
NOTE: This PIC is not supported in JUNOS Release 8.1R1.
One STM1 port
Power requirement: 0.39 A @ 48 V (18.6 W)
Intelligent queuing (IQ) PICs support fine-grained queuing per logical interface
Channelization: STM1c, fractional E1, framed and unframed DS0
Packet buffering, Layer 2 parsing
Local and remote loopback testing
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
SNMP: SONET/SDH MIB, T1/E1 MIB
Dynamic, arbitrary channel configuration
Full bit error rate test (BERT) patterns at E1 and DS0 levels
Encapsulations:
High-Level Data Link Control (HDLC)
Frame Relay
Circuit cross-connect (CCC)
Translational cross-connect (TCC)
Point-to-Point Protocol (PPP)
Duplex SC/PC connector (Rx and Tx); single-mode intermediate-reach fiber
One tricolor per port:
Off Not enabled
Green Online with no alarms or failures
Amber Online with alarms for remote failures
Red Active with a local alarm; router has detected a failure
Channelized STM1 IQ PIC
Channelized STM1 IQ PIC
43
Advertisement
Table of Contents
