2. RADAR OPERATION
2.21
Outputting TLL Data
Target position data can be output to units of the network and shown on their
plotter screen with the TTL mark (
heading data.
1. Operate the trackball to place the cursor on the target whose position you
wish to output.
2. If not displayed, press the [HIDE/SHOW] key to display the radar soft keys.
3. Press the D:TARGET soft key.
3nm
12/
LP
H-UP
4. Press the B:TLL OUTPUT soft key to output target position data. The TLL
mark appears on the plotter screen at the target's position the moment the
B:TLL OUTPUT soft key was pressed. Further, that position is recorded as a
waypoint on all NavNet units, under the youngest empty waypoint number on
each NavNet unit.
5. Press the E:RETURN soft key to finish.
Note: The screen of the TLL recipient may be temporarily interrupted when
receiving TLL from another NavNet unit. Press any key to restore normal
operation.
2-28
). This function requires position and
X
°M
319. 9
TARGET
A
TRAIL
TLL
B
OUTPUT
Requires ARP circuit board
C
ACQ
in Model 1800/1900-BB series
NavNet radar. Not shown
TARGET
D
INFO
otherwise.
E
RETURN
359.9 ˚R
+
11.70
nm
TARGET soft keys
offered by Busse-Yachtshop.de