Selecting Image Source - Furuno 1823C-BB Operator's Manual

1. OPERATIONAL OVERVIEW
1.5.4

Selecting image source

When more than one network radar or network sounder is connected to the
equipment, you may select an image source for each as shown below. This is
not necessary when only one network radar or network sounder is connected.
1. Press the [DISP] key.
2. Press any soft key to show the following display.
3. Use the trackball to select RADAR SOURCE, SOUNDER SOURCE or AUX
SOURCE as appropriate, then press the A: EDIT soft key.
RADAR SOURCE
RADAR - - -
4. Use the trackball and alphanumeric keys to enter source name: Adjust the
trackball to select location and enter character with the alphanumeric keys.
5. Push the [ENTER] knob to set.
6. Press the [DISP] key to finish.
Note: Source names are determined at installation. For example, the source
names for radars in a two-radar system might be "RADAR" and
"RADAR1".
1-10
RADAR SOURCE
SOUNDER SOURCE
AUX SOURCE
IP ADDRESS
HOST NAME
IF THERE IS MORE THAN
ONE NETWORK RADAR OR
ECHO SOUNDER, YOU MAY
SELECT THE IMAGE
SOURCES FOR DISPLAY.
Radar source
Radar source and sounder source windows
RADAR - - -
SOUNDER -
WXFAX - - -
172.031.003.007
RADAR - - -
Select source menu
SOUNDER SOURCE
SOUNDER -
Sounder source
offered by Busse-Yachtshop.de
SELECT
SOURCE
A EDIT
E RETURN
AUX SOURCE
WXFAX - - - - -
Aux source