2.21
Outputting TLL Data
Target position data can be output to units of the network and shown on their
plotter screen, with the TTL mark (
heading data.
1. If not displayed, press the [HIDE/SHOW] key to display the radar soft keys.
2. Operate the cursor pad to place the cursor on the target whose position you
wish to output.
3. Press the TARGET soft key.
4. Press the TLL OUTPUT soft key to output target position data.
5. Press the RETURN soft key to finish.
Note: The screen of the TLL recipient may be temporarily interrupted when
receiving TLL from another NavNet display unit. Press any key to restore
normal operation.
.125nm
.250/
319.9
SP
H-UP
). This function requires position and
X
M
TARGET
TRAIL
TLL
OUTPUT
Shown with selection of
ACQ
1833/C series network
radar equipped with ARP
TARGET
function as source.
INFO
Not shown otherwise.
RETURN
359.9 R
+
0.240nm
TARGET soft keys
2. RADAR OPERATION
2-29