2. Gently press down the small handle
down the small handle
Figure 48. Securing the microprocessor in the socket
1
3. Align the notch
of the microprocessor socket cover with the alignment key
socket. Lower the socket cover straight down into the microprocessor socket on the system board.
Figure 49. Installing the microprocessor socket cover
Note: Your microprocessor socket and cover might look slightly different from the illustration.
Replacing the power supply assembly
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important Safety
Information" on page 1.
This section provides instructions on how to replace the power supply assembly.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
114
ThinkStation S30 Hardware Maintenance Manual
1
and then push the handle inward to secure it. Then gently press
2
and push the handle inward to lock the microprocessor retainer into position.
2
of the microprocessor