Replacing The Power Supply Assembly - Lenovo 10GS User Manual

11. Reinstall the front bezel. See "Replacing the front bezel" on page 54.
12. Reinstall the computer cover and connect the cables. See "Completing the parts replacement" on
page 76.
13. Turn on the computer and all connected devices.
Note: When the computer is turned on for the first time after replacing the coin-cell battery, an error
message might be displayed. This is normal after replacing the coin-cell battery.
14. Use the Setup Utility program to set the date, time, and any passwords. See "Using the Setup Utility
program" on page 35.

Replacing the power supply assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii .
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
Hazardous moving parts. Keep fingers and other body parts away.
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with
one of these parts, contact a service technician.
To replace the power supply assembly, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 54.
3. Remove the front bezel. See "Replacing the front bezel" on page 54.
4. Remove the optical drive. See "Replacing the optical drive" on page 57.
.
Chapter 7 Installing or replacing hardware
75