2.
To remove the webcam/microphone module:
a.
Position the display assembly with the top edge toward you.
b.
Disconnect the cable (1) from the module.
c.
Remove the webcam/microphone module (2). (The module is attached to the display enclosure
with double-sided tape.)
3.
To remove the display panel:
a.
Remove the four Phillips PM2.5×3.5 screws that secure the display panel to the enclosure.
NOTE:
In this procedure, the display will NOT be connected to the computer, as shown in the
following image.
b.
Rotate the display panel onto the keyboard to gain access to the display cable connection on the
back of the panel (1).
Component replacement procedures
89