Installing An Iom; Installing A Poe Module In The G3G-24Tx Iom - Enterasys G3G124-24 Hardware Installation Manual

Figure 2-3
1 Fastening screws
2 PoE daughter card module
3 IOM to PoE connector
4. Using the screws shipped with the PoE module, firmly attach the PoE module to the IOM.

Installing an IOM

The following procedure describes how to install a hot‐swappable IOM into your G3G switch. You
can install an IOM into any open slot. Enterasys Networks recommends inserting any IOMs before
you connect power to the switch as described in "Connecting Power to the Switch" on page 2‐13.
Note: An IOM can be hot-inserted into the G-Series switch, but must be removed by following the
procedure described in
Caution: If you are installing multiple IOMs into a switch that is running, you must wait until the
previously installed IOM is completely initialized before attempting to install the next IOM.
Initialization is complete when the slot's status LED turns solid green. (A syslog message will also
be sent to the CLI at completion.)
Precaución: Si instala varios IOM en un switch en funcionamiento, debe esperar a que el IOM que
instaló previamente se haya activado por completo antes de pasar al siguiente. Se habrá
completado la activación cuando el LED de estado pase a color verde (asimismo se enviará un
mensaje syslog al CLI cuando se haya completado).
To install an IOM, refer to Figure
1. Confirm adequate power is available to power the new IOM. For more information about G3
power supplies, see "Power Supply Installation Considerations" on page 2‐5. For more
information about IOM power consumption, see "IOM Specifications" on page A‐3.
2. Attach an ESD wrist strap to your wrist.

Installing a PoE module in the G3G-24TX IOM

"Removing an
2‐4 on page 2‐12 and proceed as follows:
4 IOM connector
5 G3G-24TX IOM (motherboard)
IOM" on page 2-13.
Enterasys G-Series Hardware Installation Guide 2-11
Installing and Removing an IOM