D-Link xStack Reference Manual page 1030

®
xStack DGS-3120 Series Layer 3 Managed Gigabit Switch CLI Reference Guide
Parameters
vrid - specifies the ID of the Virtual Router used.
<vrid 1-255> - Enter the Virtual Router ID used here. This value must be between 1 and 255.
ipif - Specify the IP interface used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
state - (Optional) Specify the state of the virtual router function.
enable - Specify that the virtual router function will be enabled.
disable - Specify that the virtual router function will be disabled.
priority - (Optional) specifies the priority to be used for the Virtual Router Master election process
<int 1-254> - Enter the priority value used here. This value must be between 1 and 254.
ipaddress - (Optional) Specify the virtual router's IP address used.
<ipaddr> - Enter the virtual router's IP address used here.
advertisement_interval - (Optional) Specify the time interval used between sending
advertisement messages.
<int 1-255> - Enter the advertisement interval value here. This value must be between 1 and
255 seconds.
preempt - (Optional) Controls whether a higher priority virtual router will preempt a lower priority
master. The preempt setting must be consistent with all the routers participating within the
same VRRP group. Default is setting is true.
true - Specify that if the backup router's priority is set higher than the masters priority, it will
become the master instead of the current one.
false - Specify if the backup router's priority is higher than the masters priority, it will not
become the master until the master failed.
critical_ip - (Optional) specifies an IP address that will provide the most direct route to the
Internet or other critical network connections from this virtual router. This IP address must be a
real IP address of a real device on the network. If the connection from the virtual router to this
IP address fails, the virtual router will automatically be disabled. A new Master will be elected
from the backup routers participating in the VRRP group. Different critical IP addresses may
be assigned to different routers participating in the VRRP group and can therefore define
multiple routes to the Internet or other critical network connections.
<ipaddr> - Enter the critical interface's IP address used here.
critical_ip_state - (Optional) Specify the state of checking the status (active or inactive) of a
critical IP address.
enable - Specify that the critical IP state checking will be enabled.
disable - Specify that the critical IP state checking will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure VRRP:
DGS-3120-24TC:admin#config vrrp vrid 1 ipif System state enable
Command: config vrrp vrid 1 ipif System state enable
Success.
DGS-3120-24TC:admin#
113-5 config vrrp ipif
Description
This command is used to configure a virtual router authentication type on an interface.
1025