How To Use The Lifepulse Digital Heart Rate Sensors; How To Use The Heart Rate Zone Trainer Chest Strap - Life Fitness Lifecycle 9500HR Operation Manual

14
H U T L
OW TO SE HE
The patented Lifepulse digital heart rate sensors are the default heart rate monitoring
system on the Lifecycle 9500HR exercise bike. To use the Lifepulse sensors, sim-
ply grasp the stainless steel sensors in the handlebars when the display console
prompts you to do so or anytime you wish to check your heart rate. There are four
sensors, two on each side of the handlebar, and you must make contact with all four
to obtain your heart rate. The console will display your ECG-accurate heart rate in
10 to 30 seconds.
H U T H
OW TO SE HE
Wet the electrodes of the transmitter (the two grooved surfaces on the underside of
the strap) and secure the strap as high under the chest muscles as possible. The
strap should be snug, but comfortable enough to allow for normal breathing.
The transmitter strap will deliver an opti-
mum heart rate reading when the elec-
trodes are directly in contact with bare skin.
It will also, however, function properly
through wet, lightweight
clothing. The key is for
the electrodes to remain
wet so that they can con-
duct the electrical impuls-
es of the heart back to the
receiver.
If it becomes necessary to remoist-
en the chest strap transmitter, grasp the
center of the strap, pull it away from the
chest to expose the two electrodes, then moisten them in this position.
D H
IFEPULSE IGITAL
R Z T
EART ATE ONE
Zone Trainer chest strap transmitter
R S
EART ATE ENSORS
C S
RAINER HEST TRAP