Mounting Board With Rf Receiver - Honeywell ADEMCO VISTA-10P Installation And Setup Manual

Installation Instructions

Mounting Board with RF Receiver

1. a. Remove the receiver board from its case, then insert the top of the board into the slots at the top of the
cabinet, as shown in Detail A in Figure 3. Make sure that the board rests on the correct row of tabs.
b. Swing the base of the board into the mounting clips and secure it to the cabinet with the accompanying
screws.
c. Insert the top of the control's board into the slot in the clips and position two clips at the lower edge of
the board.
d. Swing this board into place and secure it with two additional screws.
2. Insert grounding lugs (supplied with the receiver) through the top of the cabinet into the left-hand
terminals of the antenna blocks (at the upper edge of the receiver board) and secure them to the cabinet
top with the screws provided, as shown in Detail B.
3. Insert the receiver's antennas through the top of the cabinet, into the blocks' right-hand terminals, and
tighten the screws.
NOTES
• Do not mount the cabinet on or near metal objects. This will decrease RF range and/or block RF
transmissions from wireless transmitters.
• Do not locate the cabinet in an area of high RF interference (revealed by frequent or prolonged lighting of
the LED in the receiver after it is operational (random flicker is OK)
CABINET
INSTALLATION WITH RECEIVER CIRCUIT BOARD
NOTE
A COMBINATION OF THESE MOUNTING CLIPS HAS BEEN
INCLUDED IN YOUR INSTALLATION KIT.
USE THE APPROPRIATE CLIPS FOR MOUNTING.
IF NO RF RECEIVER IS USED, MOUNT THE PC BOARD USING
EITHER THE WHITE OR BLACK CLIPS, WHICHEVER ARE
INCLUDED IN THE CONTROL PANEL'S HARDWARE KIT.
2-2
A
RECEIVER CIRCUIT BOARD
+ +
CONTROL
CIRCUIT
BOARD
WHITE BLACK
MOUNTING MOUNTING
CLIP CLIP
Figure 3. Mounting the PC Board and RF Receiver
B
BOARD
SUPPORTING
SLOTS
MOUNTING
CLIP
MOUNTING
CLIP
RED
MOUNTING
CLIP
CABINET
CIRCUIT
BOARD
DETAIL A
SIDE VIEW
OF BOARD -
SUPPORTING SLOTS
ANTENNA
(2)
SCREW
(2)
GROUNDING
LUG
(2)
ANTENNA
MOUNT
(2 PLACES)
DETAIL B
ANTENNA AND GROUNDING
LUG INSTALLATION
pc_mount-001-V1