Traffic Safety; Connecting An Extension Speaker; Using The Belt Clip - Radio Shack PRO-92 Owner's Manual

20-522b.fm Page 17 Thursday, September 7, 2000 9:41 AM
• Set the volume to the lowest setting before you
begin listening. After you begin listening, adjust the
volume to a comfortable level.
• Once you set the volume, do not increase it. Over
time, your ears adapt to the volume level, so a vol-
ume level that does not cause discomfort might still
damage your hearing.

Traffic Safety

Do not wear an earphone or headphones while you drive
a vehicle or ride a bicycle. This can create a traffic haz-
ard and can be illegal in some areas.
Even though some earphones and headphones let you
hear some outside sounds when you listen at normal
levels, they still can present a traffic hazard.
CONNECTING AN EXTENSION
SPEAKER
In a noisy area, an amplified speaker (not supplied),
available at your local RadioShack store, might provide
more comfortable listening. Plug the speaker cable's
inch (3.5-mm) mini-plug into your scanner's
Note: You must use an amplified speaker with this scan-
ner. Non-amplified speakers do not provide sufficient
volume for comfortable listening.

USING THE BELT CLIP

You can use the belt clip attached to the back of the
scanner for hands-free carrying when you are on the go.
Slide the belt clip over your belt or waistband.
Preparation
1
/ -
8
jack.
17