Table of Contents
Advertisement
Figure 3.9
Key
a
Open locking handle
b
Closed locking handle
To install a Supervisor module:
1
Remove the blanking plate or installed module as appropriate.
2
Open the locking handles at the edge of the front panel.
3
Position the module in the slot as shown in Figure 3.9.
4
Gently slide the module in.
Ensure the hooks on the locking handle are aligned with the matching holes on
the chassis.
5
Close the locking handles.
The module slides back and connects to the backplane.
6
Gently tighten the screws.
For information on configuring redundant supervisor modules, refer to
"M460ML-SPV Supervisor Module Redundancy" on page 35.
Avaya P460 Installation and Maintenance Guide
Chapter 3
Installing the P460 Supervisor Module
a
3
3
b
Avaya P460 Chassis and Module Installation
15
Advertisement
Table of Contents
