Outband Interface Connection Cli Commands - Avaya P460 Installation And Maintenance Manual

Chapter 7 Establishing Switch Access
You can now configure the P460.
You can connect the Out-band interface to either of the Supervisor modules.

Outband Interface Connection CLI Commands

In order to...
Configure the management
interface
Enable the outband interface
Disable the outband interface
Enable or disable the link
negotiation protocol on the Fast
Ethernet console port
Set the speed of Fast Ethernet
Console port
Set the duplex mode of the Ethernet
Console port
Display information on the device
network interfaces
Display outband interface
parameters
Send an ICMP echo request packets
to another node on the network.
44
Use the following command...
set interface outband
enable interface outband
disable interface outband
set outband negotiation
set outband speed
set outband duplex
show interface
show outband
ping
Avaya P460 Installation and Maintenance Guide