Canon CHDK Quick Start Manual page 65

performed by an authorized Canon Repair Facility, would void the warranty." ... and ... In further
discussion with Canon
warranty would be void."
Is it an "upgrade" of the camera firmware when the firmware remains untouched? It's up to you to
decide. Don't use it if you are not willing to take the slightest chance. Many many people have used
CHDK on their cameras (including some very experimental versions) and there is no report of any
permanent malfunction. Thus, CHDK appears to be quite safe to use as long as you make sure that it's
the CHDK and not a real firmware update (A real firmware update which is not an official Canon
update could alter or completely screw up the camera and will void the warranty). Addressing their
second comment (i.e. "if it is not Canon
FIRMware is software that remains in the memory of the device when it is not using any power
source.
However, this is not a legal opinion and the user accepts all risk of using it. And as a practical matter, if
you send your camera in for warranty service, and Canon
found evidence of CHDK on your memory card, there is not much you can really do (what are you
going to do? Spend thousands of dollars suing them to get your camera repaired?) However, you can
just wipe or remove the card. ;)
See:-
http://forums.dpreview.com/forums/readflat.asp?forum=1010&thread=23168653&page=2
More at: -
http://chdk.wikia.com/wiki/FAQ
Q. How do I use scripts?
A. CHDK allows you to automate your camera by running "scripts", small and simple programs
written in a short-hand version of BASIC, or Lua. You can use some pre-made scripts like bracketing,
intervalometer etc., or write your own scripts using the scripting language. To use a script, you have
to do this:
1 - Put the script you want to use into the CHDK/SCRIPTS-folder on your SD card
2 - Load the script (main menu>scripting parameters>load script from file) and adjust script
parameters as needed...
3 - To run the script, press the shutter button while in
shutter button again.
If your script does not work properly, try to increase the "script shoot delay" parameter, which is a
small time-delay after a shot is taken, before the next line of the script is executed. Some scripts also may
require certain camera settings. For example the generic bracketing script: go to menu>review and switch
it to "off". Use P, Tv, Av or M mode and activate the camera function where you want to have bracketing.
For example: Activate the focus slider when you want to have focus bracketing. Activate the exposure
compensation slider in P mode when you want to have exposure bracketing, and so on.
For more, go to:-
Scripting notes
and
http://chdk.wikia.com/wiki/UBASIC/TutorialScratchpad
Q. May I suggest a new feature?
A. Yes you certainly can, although not every wish can be fulfilled. Please note that the CHDK is not
able to change any standard behavior of the camera, because it does not modify the original
firmware. CHDK can just "extend" current functionality.
about this specific hack, their response is: "If it is not Canon
®
firmware"): CHDK is NOT firmware. By very definition,
®
Page 54,
says your warranty is void because they
®
mode. You can also stop it by pressing the
<ALT>
63
firmware the
®
®