Canon CHDK Quick Start Manual page 39

...................................
• Enable Synchable Remote
Enables synchable scriptless remote code originally used in Stereo Data Maker.
• Enable Synch
Used to synchronize 2 or more cameras when all hooked to the same USB-Remote signal.
• Enable Synch Delay
Allows you to fine-tune your USB-Remote triggering speed to
match that of other cameras when using more than 1 camera. (For
stereo imagery, multi-frame stop-action matrix effects, etc.) Rate
of delay is adjusted with the settings below.
• Sync Delay 0.1ms
USB-Remote Sync delay in 0.1ms increments (1/1000th of a second).
• Sync Delay 0.1s
USB-Remote Sync delay in 0.1s increments (1/10th of a second).
• Enable Remote Zoom
To enable the zoom by remote control function.
• Zoom Time-out 0.1s
Set a value for time-out, 0.1s x 2 up to 10.
Load Default Param Values
CHDK normally saves your last user-selected script parameters from one session to the next.
Press
FUNC.SET
as programmed into the script when first ran. A simple way to go back to a script's defaults after
you've gotten hopelessly lost in many changes or just need a quick way to return to base settings.
Parameters Set
Allows for the selection of 0 to 9 (ten) optional parameter sets for each script. If you select a
new Parameter Set and then change your user-setting script parameters, CHDK will now
remember your settings for each set. (The script parameter sets are saved in a CHDK/DATA/
directory named by the script in use at the time.) Now you can have up to 10 favorite settings for
any one script. The next time you load the same script your favorite defaults can be called-up by
just selecting numbers 0 to 9.
Save params
Save current parameter settings.
See USB Remote
synchable remote
Enable [•] / Disable [ ]
[ 2 - 10 ]
when your menu cursor is on this option resets them to the default parameters
Enable [•] / Disable [ ]
notes, page 52.
........................................
Enable [•] / Disable [ ]
Enable [•] / Disable [ ]
Enable [•] / Disable [ ]
37