Emergency Door Opening - AEG L 99695 HWD User Manual

36 www.aeg.com
Problem
The washing cycle is longer
than the time displayed.
The internal lamp is off.
After a steam programme,
garments are partially wet.
After a steam programme,
garments are not sufficiently
smooth.
The appliance does not dry
or does not dry correctly.
The drying cycle is too long.
The laundry is full of differ-
ent colours fluff.
There is a big quantity of
fluff in the drum.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.

15.3 Emergency door opening

In case of power failure or appliance
failure the appliance door remains
locked. The washing programme
continues, when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock feature.
Before opening the door:
Possible solution
An unbalanced laundry load increases the duration time.
This is a normal behaviour of the appliance.
Make sure that he lamp is not burned. To replace the
lamp, contact the service centre.
Make sure that the appliance is accurately levelled. Ad-
just the appliance by raising or lowering the feet.
Make sure that you set a correct STEAM programme (e.g.
Synthetic instead of Cotton).
Make sure the water tap is not closed.
Make sure the drain filter is not clogged.
Make sure you have set the correct cycle. If necessary, set
again a short drying time.
Make sure that the room temperature is in the correct
range.
Set a drying cycle to remove some fluff.
Clean the laundry with a fluff remover.
In case of an excessive amount of fluff in the drum run the
special programme to clean it (refer to "FLUFF IN THE
FABRICS" for more details).
CAUTION!
Make sure that the water
temperature and the
laundry are not hot. Wait
till they cool down, if
necessary.
CAUTION!
Make sure that the drum is
not rotating. Wait till the
drum stops rotating, if
necessary.