Troubleshooting - AEG L 99695 HWD User Manual

compartment of the detergent
dispenser.
2. Start the programme to drain the
water
14.10 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.

15. TROUBLESHOOTING

15.1 Introduction
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the Authorised
Service Centre.
With some problems, the acoustic signals operate and the display shows an alarm
message:
15.2 Possible failures
Problems with alarm messages
Message
The display tells to check the
tap: the appliance does not
fill with water.
WARNING!
Refer to Safety chapters.
CAUTION!
Deactivate the appliance before you do the checks.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
Possible solution
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authori-
ty.
Make sure that the water tap is not clogged or is furred
with lime-scale.
Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to "Care and cleaning".
Make sure that the inlet hose is not damaged.
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again. The
manufacturer is not
responsible for damages
caused by low temperatures.
ENGLISH 33