Table of Contents
Advertisement
1 Launch TABM and allow the autodiscovery process to occur. Locate the
2 Enter the superuser password for the selected AccessBuilder.
3 Under the TABM System menu, select the Download/Upload dialog
4 Enter the appropriate IP address of the TFTP server on which you have
5 Select the desired function from the Download/Upload dialog box by
What To Do If An
Image Download
Fails
target AccessBuilder in the View All Servers list and double-click on the
unit.
box.
placed the AccessBuilder files.
clicking on the appropriate radio button, then click on the OK bar.
The following table lists the AccessBuilder file names associated with
each function.
Table B-1 AccessBuilder Download/Upload TFTP Filenames
AccessBuilder
Software
Model
Image
2000
ntksrvr
4000
absrvr
In the event of a failed file transfer, a failed transfer message prompt
will be issued by the AccessBuilder.
The AccessBuilder server then resets and resumes normal operation.
The download/upload procedure is now complete.
The image download procedure is handled by the AccessBuilder's
internal executive monitor firmware, called "nindy". Normally, when
an image download is completed, the new image is copied into Flash
memory and the AccessBuilder automatically resets. In the event an
image download fails, the AccessBuilder should reset with the old
image. There is a possibility, however, that during the download
attempt a failure could occur which would erase the old image.
Should this occur, the AccessBuilder remains in the nindy mode and
cannot automatically reset. To recover, perform the procedures on
page B-9.
Configuration
Download
ntkdncfg.cfg
abdncfg.cfg
TABM
B-3
Configuration
Upload
ntkupcfg.cfg
abupcfg.cfg
Advertisement
Table of Contents
