Horizon Fitness EX-67 User Manual page 6

AS SE MB LY ST EP 
A) Open HARDWARE BAG FOR STEP 4.
B) Attach the PEDAL ARM COVER using 1 SCREW (J).
C) Attach the ROLLER WHEEL COVER using 1 SCREW (K).
D) Repeat on other side.
HARDWARE BAG FOR STEP  CONTENTS :
10
EX-67_Rev.1.6.indd 10-11
PEDAL ARM
PEDAL ARM COVER
SCREW (J)
SCREW (K)
ROLLER WHEEL COVER
SCREW (J) SCREW (K)
15 mm 12 mm
Qty: 2 Qty: 2
ASSEMBLY STEP 
PRE-ATTACHED BOLTS AND WASHERS
CONSOLE MAST
LOWER HANDLEBAR
A) Open HARDWARE BAG FOR STEP 5.
B) Remove PRE-ATTACHED BOLTS and WASHERS from CONSOLE MAST.
C) Slide right LOWER HANDLEBAR on CONSOLE MAST and attach by reinserting PRE-ATTACHED BOLT and WASHERS.
D) Slide SPACER (O) into LOWER HANDLEBAR.
E) Place TEFLON WASHERS (N) on either side of SPACER (O). While holding TEFLON WASHERS (N) slide LOWER
LINK ARM into bottom end of LOWER HANDLEBAR.
F) Insert BOLT (M) into LOWER HANDLEBAR and secure using NUT (P).
E) Repeat on other side.
HARDWARE BAG FOR STEP  CONTENTS :
BOLT (M)
60 mm
Qty: 2
TEFLON WASHER (N)
28.4 mm
Qty: 4
LOWER
LOWER LINK ARM
HANDLEBAR
TEFLON WASHERS
UPPER HANDLEBAR
SPACER
PRE-ATTACHED SCREWS
LOWER HANDLEBAR
NUT (P)
BOLT (M)
SPACER (O)
TEFLON WASHER (N)
LOWER LINKARM
SPACER (O)
44 mm axis
Qty: 2
NUT (P)
INSIDE DIAMETER:
8 mm
Qty: 2
11
7/7/08 4:29:18 PM