Using The Setup Utility - IBM System x3650 M4 Type 7915 Problem Determination And Service Manual

v View the readme file to review installation tips for your operating system and
v Start the operating-system installation. You will need your operating-system CD.
Important: Before you install a legacy operating system (such as VMware) on a
server with an LSI SAS controller, you must first complete the following steps:
1. Update the device driver for the LSI SAS controller to the latest level.
2. In the Setup utility, set Legacy Only as the first option in the boot sequence in
3. Using the LSI Configuration Utility program, select a boot drive.
Typical operating-system installation
The ServerGuide program can reduce the time it takes to install an operating
system. It provides the device drivers that are required for your hardware and for
the operating system that you are installing. This section describes a typical
ServerGuide operating-system installation.
Note: Features and functions can vary slightly with different versions of the
ServerGuide program.
1. After you have completed the setup process, the operating-system installation
2. The ServerGuide program stores information about the server model, service
3. The ServerGuide program presents operating-system partition options that are
4. The ServerGuide program prompts you to insert your operating-system CD and
Installing your operating system without using ServerGuide
If you have already configured the server hardware and you are not using the
ServerGuide program to install your operating system, go to http://www.ibm.com/
supportportal/ to download the latest operating-system installation instructions from
the IBM website.

Using the Setup utility

Use the Unified Extensible Firmware Interface (UEFI), formerly BIOS, Setup utility
to perform the following tasks:
v View configuration information
v View and change assignments for devices and I/O ports
v Set the date and time
v Set the startup characteristics of the server and the order of startup devices
v Set and change settings for advanced hardware features
v View, set, and change settings for power-management features
v View and clear error logs
v Resolve configuration conflicts
adapter.
the Boot Manager menu.
program starts. (You will need your operating-system CD to complete the
installation.)
processor, hard disk drive controllers, and network adapters. Then, the program
checks the CD for newer device drivers. This information is stored and then
passed to the operating-system installation program.
based on your operating-system selection and the installed hard disk drives.
restart the server. At this point, the installation program for the operating system
takes control to complete the installation.
Chapter 6. Configuration information and instructions
301