Removing A Usb Hypervisor Memory Key - IBM System x3650 M4 Type 7915 Problem Determination And Service Manual

Removing a USB hypervisor memory key

To remove a USB hypervisor memory key, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Slide the server out of the rack.
4. Remove the cover (see "Removing the cover" on page 205).
5. Unlock the retention latch on the USB connector by squeezing the two retention
6. Open the retention latch.
7. Grasp the flash device and pull to remove it from the connector.
8. If you are instructed to return the hypervisor memory key, follow all packaging
Note: You must configure the server not to look for the hypervisor USB drive. See
"Configuring the server" on page 298 for information about disabling hypervisor
support.
216
IBM System x3650 M4 Type 7915: Problem Determination and Service Guide
USB embedded
hypervisor
flash device
on page 191.
external cables.
clips toward each other.
instructions, and use any packaging materials for shipping that are supplied to
you.
Lockbar