Removing The Optional Dual-Port Network Adapter - IBM System x3650 M4 Type 7915 Problem Determination And Service Manual

4. Press down on the assembly. Make sure that the riser-card assembly is fully
5. Perform any configuration tasks that are required for the adapter.
6. Install the server cover (see "Installing the cover" on page 206).
7. Slide the server into the rack.
8. Reconnect the external cables; then, reconnect the power cords and turn on the

Removing the optional dual-port network adapter

To remove the network adapter, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the cover (see "Removing the cover" on page 205).
4. Remove the PCI riser-card assembly 2 (see "Removing a PCI riser-card
5. Loosen the thumbscrew on the rear of the chassis.
6. Grasp the network adapter and disengage it from the pin, standoffs, retention
224
IBM System x3650 M4 Type 7915: Problem Determination and Service Guide
v PCI-riser connector 1: Carefully fit the two alignment slots on the side of the
assembly onto the two alignment brackets on the side of the chassis; align
the rear of the assembly with the guides on the rear of the server.
v PCI-riser connector 2: Carefully align the bottom edge (the contact edge) of
the riser-card assembly with the riser-card connector on the system board;
align the rear of the assembly with the guides on the rear of the server.
seated in the riser-card connector on the system board.
peripheral devices and the server.
on page 191.
external cables.
assembly" on page 218).
Network
adapter
Retention
brackets
brackets, and the connector on the system board; then, lift the adapter out of
the port openings on the rear of the chassis and remove it from the server.
Captive screws
Thumbscrew
Pin
Network
adapter connector
Screw holes