Ricoh C252 Service Manual page 159

INSTALLATION PROCEDURE
Installation Procedure
CAUTION
To avoid serious injury, do not connect the power plug to the machine until
you are instructed to do so.
⇒
1. Unpack the machine and remove all the wrapping.
2. Remove all filament tape and string securing the covers and units as shown
above.
Important note for installation:
A Styrene foam sponge is used to ensure
that the rear shipping tape stays properly
fixed in place, which prevents the printing
pressure release lever from unlocking. At
installation, please remove the rear tape
by pulling the portion shown in the photo
below toward the front of the machine.
Remove the tape and tag securing the
Press Roller during transport.
If they are not removed, paper jams or
blank images may occur, due to the lack
of pressure on the Press Roller and the
tape may stick to the drum screen or
Press Roller.
C252
Rear Tape
Front Tape
1-4
Rev. 11/2003
C252I004.WMF
Tag
SM