Oki C301 User Manual page 58

ITEM
OP MENU FX EMULATION
(cont.)
USB MENU
NETWORK MENU
MEMORY MENU
SYS ADJUST
MENU
MAINTENCE
MENU
USAGE MENU
CONFIG. MENU NEARLIFE
STATUS
LIFE WARNING
NEARLIFE LED
ECO MODE
SETTINGS EXPLANATION
ENABLE Set up ENABLE/DISABLE condition for FX
EMULATION category.
DISABLE
If DISABLE is selected, FX EMULATION
category of USERS MENU will not appear.
ENABLE Set up ENABLE/DISABLE condition for USB
MENU category.
DISABLE
If DISABLE is selected, USB MENU category
of USERS MENU will not appear.
ENABLE Set up ENABLE/DISABLE condition for
NETWORK MENU category.
DISABLE
If DISABLE is selected, NETWORK MENU
category of USERS MENU will not appear.
ENABLE Set up ENABLE/DISABLE condition for
MEMORY MENU category.
DISABLE
If DISABLE is selected, MEMORY MENU
category of USERS MENU will not appear.
ENABLE Set up ENABLE/DISABLE condition for
SYS.ADJUST MENU category.
DISABLE
If DISABLE is selected, SYS.ADJUST MENU
category of USERS MENU will not appear.
ENABLE Set up ENABLE/DISABLE condition for
MAINTENACE MENU category.
DISABLE
If DISABLE is selected, MAINTENANCE MENU
category of USERS MENU will not appear.
ENABLE Set up ENABLE/DISABLE condition for
USAGE MENU category.
DISABLE
If DISABLE is selected, USAGE MENU
category of USERS MENU will not appear.
ENABLE Set LCD panel control at the time of near-life
warning for drum, fuser and belt.
DISABLE
Enable: Display a near-life warning.
Disable: Do not display a near-life warning.
ENABLE If DISABLE is selected, the printer does not
display life warning after cover opening and
DISABLE
closing.
Display Condition: NEARLIFE STATUS is set
to DISABLE.
ENABLE Enables/disables illumination of front panel
LED when "near-end-of-life" warning of a
DISABLE
toner, drum, fuser, or belt occurs.
Attention LED is lit when setting is enabled,
inhibited when disabled.
ON When ON, if the machine is in power save
mode and you send a small print job (1 or 2
OFF
pages), the machine will print the job
without warming the fuser to the "normal"
operating temperature beforehand.
When you change the setting and exit the
Admin Menu, the machine will power cycle
then the following message is displayed
"PLEASE POWER OFF/ON". Switch the power
off then turn the machine back on.
Menu functions > 58