Oki C301 User Manual page 52

ITEM
FRAME TYPE
IP ADDRESS SET
IPV4 ADDRESS
SUBNET MASK
GATEWAY ADDRESS
WEB
TELNET
FTP
IPSEC
SNMP
NETWORK SCALE
HUB LINK SETTING
TCP ACK
FACTORY DEFAULTS
SETTINGS
AUTO / 802.2 / 802.3 /
ETHERNET II / SNAP
AUTO / MANUAL
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
ENABLE / DISABLE
ENABLE / DISABLE
ENABLE / DISABLE
ENABLE / DISABLE
ENABLE / DISABLE
NORMAL / SMALL
AUTO NEGOTIATE
100BASE-TX FULL
100BASE-TX HALF
10BASE-T FULL
10BASE-T HALF
TYPE 1
TYPE2
EXECUTE
Menu functions > 52
EXPLANATION
Applies to C331 and C531/ES5431 only.
Selects the Ethernet MAC layer frame type.
Display Condition: Netware should be enabled.
Specifies whether IP address allocation is automatic
(DHCP) or manually assigned.
Current assigned IP address. To change, press OK and
use Menu buttons to increment 1st octet, then press
OK again to move on to next octet. When 4th octet has
been set, press OK again to register new address.
Current assigned subnet mask. To change, proceed as
above.
Current assigned gateway address. To change, proceed
as above.
Enables or disables Web config. facility.
Enables or disables Telnet config. facility.
Enables or disables communication via FTP.
Applies to C331 and C531/ES5431 only.
Sets Enable/Disable of IPSec. Enable via the web.
Enable: IPSec is available.
Disable: IPSec is not available.
Enables or disables SNMP protocol.
Selects network size.
When NORMAL is selected, printer can work effectively,
even when connected to a HUB that has a spanning
tree
feature. However, printer start up time gets longer
when computers are connected with two or three small
LANs.
When SMALL is selected, computers can cover from two
or three small LANs to a large LAN, but may not work
effectively when connected to a HUB that has a
spanning tree feature.
Sets full or half duplex for communication via a network
hub.
When AUTO is set, negotiation is done automatically.
This setting determines whether the network card in
the Printer/MFP will acknowledge every TCP packet or
whether it will delay it's acknowledgement until
multiple packets have been received.
When Type 1 is set the Printer/MFP will respond to
every TCP packet with an ACK packet.
When Type 2 is set the Printer/MFP will delay it's TCP
ACK response.
In most environments the default TCP ACK setting
should be OK, however changing this setting may be
beneficial when a connection problem (e.g your printing
job incompletely terminates) occurs if it takes a long
time to interpret/print your job.
Reloads the settings present when the unit was setup
by the manufacturer.