Table of Contents
Advertisement
ITEMS
WAIT TIMEOUT
LOW TONER
JAM RECOVERY
ERROR REPORT
PCL
EMULATION
This menu controls settings effective when the printer is operating in PCL emulation mode.
ITEMS
FONT SOURCE
FONT NO.
FONT PITCH
FONT HEIGHT
SYMBOL SET
A4 PRINT WIDTH
WHITE PAGE SKIP
CR FUNCTION
LF FUNCTION
PRINT MARGIN
TRUE BLACK
SETTINGS
5~40 SEC~300, OFF
CONTINUE
STOP
ON
OFF
ON
OFF
SETTINGS
RESIDENT /
RESIDENT2
I0 ~ I90
0.44CPI~
10.00CPI~
99.99CPI
4.00 POINT~12.00
POINT~999.75 POINT
PC-8
(Default Symbol Set
only shown)
78 COLUMN
80 COLUMN
OFF / ON
CR / CR+LF
LF / LF+CR
NORMAL
1/5 INCH
1/6 INCH
OFF / ON
Menu functions > 48
EXPLANATION
Specifies how many seconds the printer will wait when
received data pauses before forcing a page eject. In
PostScript Emulation mode the job will be cancelled if
timeout occurs.
Specifies whether the printer should continue printing
even after a low toner condition is detected.
Specifies whether the printer should perform jam
recovery after a paper jam has occurred. If ON, the
printer will attempt to re-print any pages lost due to a
paper jam once the jam has been cleared.
If ON, the printer will print error details when a
PostScript Emulation error occurs.
Note: Applies tp PS & PCL XL only.
EXPLANATION
Specifies the location of the PCL default font. Normally
this will be INTERNAL unless additional fonts are
installed in the expansion ROM slot or additional fonts
have been downloaded to RAM as permanent fonts.
Sets the current default font number from the currently
selected source.
Sets the width of the PCL default font in characters/inch
(CPI).
Default font is the fixed-pitch, scalable font. The value is
displayed to the second decimal place
Displayed only when the font selected in Font No. is
fixed-spacing, scalable font.
Height of the PCL default font.
Note: This menu item is displayed only when the font
selected in Font No. is a proportional-spacing, scalable
font.
PCL symbol set. If the font source and number are
changed to one which does not support the selected
symbol set, this must be changed to an available
symbol set for that font.
Sets the number of columns subject to Auto LF with A4
paper in PCL. This is the value when Auto CR/LF Mode is
set to OFF with the 10CPI character.
Selects whether blank pages are printed or not.
Selects whether a received carriage return character
(0Dh) also causes a line feed.
Selects whether a received line feed character (0Ah)
also causes a carriage return.
Sets the non-printable page area. NORMAL is PCL
compatible.
Selects whether black image data is printed using black
toner (ON) or 100% CMY (OFF). (Valid in PCL emulation
mode only.)
Advertisement
Table of Contents
