Sharp AL-1661CS Service Manual page 112

Main Sub
Contents
code code
66 32 Receive data check
33 Signal detection check
34 Communication time
measurement
37 Speaker sound volume
setting
[Function]
Use to check the receive data.
[Operation]
1) Initial display
RECEIVING
[Function]
Use to check the signal detection.
[Operation]
1) Initial display
CHECKING
PRESS CLEAR TO STOP
When a signal is detected, the display is changed from NONE to the following.
CI/CNG/CED/BT/DT/Flag/SDT/DTMF
[CLEAR] key: FAX control is terminated.
[Function]
Use to measurement the communication time.
[Operation]
1) Initial display
COMM. TIME
xx:xx:xx:xxx msec
"xx:xx:xx:xxx" indicates o'clock, minute, second, millisecond.
[CLEAR] key: FAX control is terminated.
[Function]
Use to set the speaker sound volume.
1: NO SOUND
2: LOW
3: MID
4: HIGH
[Operation]
1) Initial display
SELECT SPEEKER VOL.
PRESS ,
2) [ / ] or after 2sec
Every time when [ ] key is pressed, the second line is changed in the sequence of 1
4 1.
When [ ] key is pressed, the sequence is reversed.
SELECT (1-4)
1:NO SOUND
[CLEAR] key: FAX control is terminated.
3) [ENTER] key
STORED
xxx
xxx: Set content
After 2sec, FAX control is terminated.
AL-1661CS TEST COMMAND, FAX SOFT SWITCH, TROUBLE CODES 10 - 36
Details of function/operation
2) After completion of reception
RESULT
"xx" is "OK" or "NG" depending on the check
result.
[CLEAR] key: FAX control is terminated.
NONE
SELECT (1-4)
2:LOW
xx
2 3
.....