Sharp AL-1661CS Service Manual page 111

Main Sub
Contents
code code
66 18 DTMF signal send (Soft SW
set value)
21 FAX information print
24 FAST SRAM clear
30 TEL/LIU status change
check
[Function]
Use to set the DTMF signal send (Soft SW set value).
[Operation]
1) Initial display
INPUT DIAL #
[CLEAR] key: FAX control is terminated.
2) [10KEY] input
The content selected with signal send level
selection is set inside.
[Function]
Use to print the FAX information.
[Operation]
1) Initial display
SELECT REPORT (1-3)
PRESS ,
2) [ / ] or after 2sec
Every time when [ ] key is pressed, the second line is changed in the sequence of 1
1.
When [ ] key is pressed, the sequence is reversed.
SELECT REPORT (1-3)
1:USER SW. LIST
[CLEAR] key: FAX control is terminated.
3) [ENTER] key
• When print is allowed
PRINT STORED
After completion of printing,
FAX control is terminated.
[Function]
Use to clear the FAST SRAM.
[Operation]
1) Initial display
CLEAR FAST SRAM
[Function]
Use to check the TEL/LIU status change.
[Operation]
1) Initial display
HS2 :xxx HS1 :xxx
RHS :xxx EXHS:xxx
The disdplay is switched every 2sec.
CHECKING
PRESS CLEAR TO STOP
[CLEAR] key: FAX control is terminated.
AL-1661CS TEST COMMAND, FAX SOFT SWITCH, TROUBLE CODES 10 - 35
Details of function/operation
3) Communication is started after setting the
signal send level.
SENDING SIGNAL SSW
PRESS CLEAR TO STOP
[CLEAR] key: Returns to "1) Initial display".
SELECT REPORT (1-3)
2:SOFT SW. LIST
• When print is inhibited
CAN NOT PRINT
After 2sec, FAX control is
terminated.
2) After completion of clearing
CLEARED
After 2sec, FAX control is terminated.
2 3
SELECT REPORT (1-3)
3:PROTOCOL