Replacing The Stand Assembly; Procedure - Dell Inspiron 20 Owner's Manual

Replacing the Stand Assembly

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your
computer, follow the instructions in
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.

Procedure

Follow the steps below to replace either the stand base or the stand riser:
1 Slide the stand base into the slot on the stand riser.
2 Tighten the captive thumbscrew and fold the screw handle on the stand
base.
Follow the steps below to replace the stand assembly:
3 Slide the tabs on the stand assembly into the slots on the back cover.
4 Replace the screws that secure the stand assembly to the display-panel
base.
5 Slide the tabs on the stand cover into the slots on the back cover and
snap the stand cover until it clicks into place.
Computer. After working inside your
After Working Inside Your
19