Replacing The Stand Assembly; Procedure To Replace Easel Stand; Procedure To Replace Pedestal Stand; Procedure To Replace Stand Riser To Stand Base - Dell W12C Service Manual

Replacing the stand assembly

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Procedure to replace easel stand

NOTE: The type of stand assembly varies depending on the
configuration you ordered.
1 Slide the tabs on the stand into the slots on the back cover.
2 Replace the screws that secure the stand to the display-panel base.
3 Slide the tabs on the stand cover into the slots on the back cover and
snap the stand cover until it clicks into place.

Procedure to replace pedestal stand

NOTE: The type of stand assembly varies depending on the
configuration you ordered.
1 Insert the tabs on the stand bracket with the slots on the back cover to
align the screw holes on the stand bracket to the screw holes on the
back cover.
2 Replace the screws that secure the stand bracket to the back cover.
3 Slide and replace the stand cover on the stand bracket.

Procedure to replace stand riser to stand base

1 Slide the stand base into the slot on the stand riser.
2 Tighten the captive thumbscrew and fold the screw handle on the stand
base.
22
computer. After working inside your
After working inside your