Table of Contents
Advertisement
Replacing the Stand Assembly
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in
inside your computer, follow the instructions in
safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Procedure
1.
Slide the tabs on the stand assembly into the slots on the back cover.
2.
Lower the stand assembly to lock it into place.
If you have removed the stand base from the stand riser, follow the steps below:
3.
Align the captive thumbscrew on the stand base with the screw hole on the stand riser and tighten it.
4.
Fold the screw handle on the stand base.
Removing the Back Cover
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in
inside your computer, follow the instructions in
safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Prerequisites
Remove the
stand
assembly.
Procedure
CAUTION: Do not remove the computer cover unless you need to install internal accessories for
your computer.
1.
Slide the release latches to the unlocked position indicated by a circle.
14
Before Working Inside Your
After Working Inside Your
Before Working Inside Your
After Working Inside Your
Computer. After working
Computer. For more
Computer. After working
Computer. For more
Advertisement
Table of Contents
