2.
Remove the RJ-11 connector cable from the clips and routing channel (2) built into the base
enclosure.
3.
Remove the RJ-11 connector cable from the base enclosure.
Reverse this procedure to install the RJ-11 connector cable.
ExpressCard assembly
Description
ExpressCard assembly
Before removing the ExpressCard assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Fan (see
e.
Heat sink (see
f.
Switch cover (see
g.
TouchPad (see
88
Chapter 4 Removal and replacement procedures
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Fan on page
60)
Heat sink on page
Switch cover on page
TouchPad on page
45).
49)
52)
56)
61)
69)
66)
Spare part number
495085-001