Correcting Image Distortion - Kodak 3000DSV-E Operator's Manual

Correcting Image
Distortion
3-22
You can set up the scanner-printer to automatically correct any slight
image distortion that occurs during scanning.
1. Press and hold the Shift key and the Paper Selection key.
2. Select U2 in the User mode.
3. Press the Exposure Mode key to display d*. The table below shows
the amount of correction based on the setting value:
Code
d0
d1
d2
d3
d4
d5
d6
d7
d8
4. Press the Exposure Adjustment key (Darker or Lighter) to select the
desired setting value.
5. Press the Start key to validate the setting.
NOTE: This setting returns to the default value (d3) when the Power
switch is turned off. You can register this setting by using the
Job Program function.
Setting Value
0 mm
0.5 mm
1.0 mm
1.5 mm
2.0 mm
2.5 mm
3.0 mm
3.5 mm
4.0 mm
A-61371 September 2004