Chapter 5. FUNCTIONS
5 - 3
Mode types
Program operation
Constant value control
READY
5-24
Mode
Modes are listed below.
Mode
Program operation
Constant value
control
The program is run according to SP, time, events and other settings made in
program patterns 1-49.
The control is run according to SP and events made with the constant value control
data.
READY indicates that the program is ready to run.
MV becomes fixed and events whose operation depends on values set in the
segments are turned off. Note, however, that DCP552 state dependent events still
run.
Program numbers between 1 to 49 and set segment numbers can be selected during
program operation.
All setup data, some event configuration data and some constant value control data
parameters can be changed in the READY mode.
Memory cards can also be used in the READY mode
READY
AUTO
MANUAL
READY FAST
AUTO
MANUAL
RUN
AUTO
MANUAL
HOLD
AUTO
MANUAL
FAST
AUTO
MANUAL
END
AUTO
MANUAL
READY
AUTO
MANUAL
RUN
AUTO
MANUAL