Autoload; Key Operated Autoload Procedure - Honeywell DCP552 Mark II User Manual

Chapter 9. MEMORY CARD OPERATIONS
9 - 4
Insert a memory card, press the LOAD key or use external switch inputs in the READY mode and the normal
display mode to load file number 1 in CH1 and CH2 on the memory card as program 1 onto the DCP552.

Key operated autoload procedure

Conditions
Operation and action
Handling Precautions
9-10

Autoload

Memory card
Variable parameter : PA05 set to 1
Mode
Insert a memory card and press the LOAD Key.
The DCP552 operates as follows.
• "AUtO " is displayed in display panel 1 and "LOAd " is displayed in display
panel 1.
• When program number 1 has been loaded onto the DCP552, program number
1 disappears.
• File number 1 on a memory card is loaded onto the DCP552 as program
number 1.
• When a load operation is successful, the "AUtO " and "LOAd " indications go
off and the normal display mode appears.
Unless the number of a program is selected using external switch inputs,
program 1 in segment 1 is selected.
• If the load operation fails, the "AUtO " and "LOAd " indications stay on and an
error code is displayed in the message panel.
When an error has occurred, press the DISP key to return to the normal display
mode.
A normal load operation cannot be performed when variable parameter
PA05 is set to 1. A normal load operation requires that parameter PA05 is
set to 0.
: Program has been saved to file number 1
: READY mode, normal display mode