Load Procedures; Load Menu - Honeywell DCP552 Mark II User Manual

Chapter 9. MEMORY CARD OPERATIONS
9 - 3
Insert a memory card when the DCP552 is in the READY mode and the normal display mode, and variable
parameter PA05 has been set to 0. Press the LOAD key to start a load operation. "CArd " is displayed in display
panel 1 and "LOAd " is displayed in display panel 2. An error code appears if something should go wrong during
the save operation.

Load menu

Load individual programs
L o a d C a r d - - - > D C P
P r o g r a m ?
Load all programs
L o a d C a r d - - - > D C P
A l l P r o g r a m s ?
Load setup data
L o a d C a r d - - - > D C P
S E T U P D a t a ?
Load variable parameters
L o a d C a r d - - - > D C P
P A R A D a t a ?
Load PID parameters
L o a d C a r d - - - > D C P
P I D D a t a ?
Load event configuration data
L o a d C a r d - - - > D C P
E V E N T D a t a ?
Load all parameters
L o a d C a r d - - - > D C P
A l l P a r a m e t e r s ?
9-6

Load Procedures

When the LOAD key is pressed in the normal display mode, the load menu panel
is displayed. Use the ENTER key to select the desired menu.
Press the ENTER key to display the desired menu in the message display panel.
The DISP key returns you to the normal display mode.
Note, however, that an autoload operation is performed when the LOAD key is
pressed and variable parameter PA05 is set to 1.
For details, see "Section 9-4 Autoload" (page 9-10) .
A RAM memory card whose internal batteries are too low, cause a card battery
alarm panel to be displayed before the Load menu panel is displayed.
Normal display mode
key
key
key
key
key
key
key
key
key
key
key
key
key
key
key
key
DISP key
LOAD key
ENTER key
Procedures for loading single programs (page 9-7)
ENTER key
Procedures for loading all programs (page 9-8)
ENTER key
Procedures for loading setup data (page 9-8)
ENTER key
Procedures for loading variable parameters (page 9-8)
ENTER key
Procedures for loading PID parameters (page 9-8)
(including fixed command control data)
ENTER key
Procedures for loading event configuration data (page 9-9)
ENTER key
Procedures for loading all parameters (page 9-9)