Chapter 7. Parameter Setup; Parameter Setup; Selecting Parameter Settings Groups; Progression Of Individual Items In Parameter Settings - Honeywell DCP552 Mark II User Manual

Chapter 7.
7 - 1

Parameter Setup

Parameter settings can be changed when the DCP552 is in the normal display mode.
When not in the normal display mode, press the DISP key to invoke it.

Selecting parameter settings groups

PARA key
FUNC + PARA key
PID key
(In program run mode)
PID key
(In constant value
control mode)
SETUP key
(In READY mode)
FUNC + PID key
(In READY mode)

Progression of individual items in parameter settings

PARAMETER SETUP
In the normal display mode, the keys listed in the table below can be used to select
settings groups and individual items in these groups.
Variable parameter
Event configuration data
PID parameter
Constant value control
data (does not include
Setup data
Constant value control data
Individual items in each settings group are listed below.
Variable parameter
Event configuration data
PID parameters
Setup data
Constant value control data :ConSt when using FUNC + PID key
The item codes for individual (specific) items are shown on display panel 1, their
set values are shown on display panel 2 and their mnemonic codes are shown on
the message panel.
Individual items are displayed in the vertical-horizontal matrix shown on page 7-3,
with matrix sizes varying according to settings group. The ↑ key, ↓ key, ← key
and → key are used to cycle through individual items.
The PARA key (valid for variable parameters and event configuration data), PID
key (valid for PID parameters and constant value control data) or the SETUP key
(valid for setup data) allow you to search for displayable items in ascending order
of item number.
Setting: not displayed when variable parameter
setting is more than 1
PA01
Setting: not displayed when variable parameter
setting is more than 1
PA01
Setting: not displayed when variable parameter
setting is more than 1
)
PA01
ConSt
Setting: not displayed when variable parameter
setting is more than 0
PA01
Setting: not displayed when variable parameter
setting is more than 1
PA01
: PA01
: E01-t
: P-1 in READY mode
Use P setting in the used PID group in modes other
than READY mode.
: C01
SP when using the PID key in constant value
control mode
7-1