Table of Contents
Advertisement
Installation
Installation
location and cleaning
Select for installation a location where the stand can be
placed completely horizontal or where the front edge of the
support (petal-shaped part) can be attached horizontally as
shown in Figure A.
Do not install in locations where the entrre support IS at a
diagonal such as in Figure I3 or where the monrtor unrt is
facing down such as in Figure C.
Thoroughly wipe away and dust or grease from the
installation location using a cloth whrch has been soaked in
a neutral cleaning agent and wrung out. Attach the stand
after allowing the installation location to dry
I I
Accessory@
I
Protectwe strfp
Loosen
AI
Accessory @
(04x 12 mm)
1 Bend the stand support to conform to the shape of
the rnstallatron location.
2 Adjust the shape of the support so that there IS no
rattling or gap when the stand is placed on the
support.
3 Peel off the protectrve strip from the double-sided
tape on the bottom of the sta'nd and securely attach
the stand.
1 ACAUTION
1
l
Do not attach the double-sided
tape more than once
or touch the adhesrve with your fingers as this will
weaken its adhesive strength.
l
If the temperature
of the surface of the installation
locatron is low, warm rt up using a heater or other
means before attaching the stand.
Low
temperature
may weaken the adhesive strength of
the tape.
l
The supplred stand is specrally Intended for thus
product. Do not use it with another televisron.
4 Secure the stand usrng the supplred tapping screw
(Accessory 0).
5 After attaching the stand, allow It to sit undisturbed
for 24 hours.
6 Take care not to apply any force to the stand during
this time.
7 Fully loosen the Installation screws, align the slit on
the rear of the unit with the installation shoe and slide
the monitor unit onto the stand.
8 Adjust the height, horizontal angle and vertical angle
of the monitor and securely tighten the installation
screws.
You can also adjust the monitor unit's forward
posrtron by loosening the angle adjustment.knobs
and
adjusting the angle of the monitor unrt's installation
stand.
Installation surface
Advertisement
Table of Contents
