Table of Contents
Advertisement
lnstalla tion
External view
External view
External view
Number of items
.
Number of items
. . . . . Number of items
(04xi2mm)
5
@I $@@ *
1
@ <04xl6mm)
4
1
2
3
4
5.
6.
7.
To prevent short clrcults, remove the key from the
lgnitlon and dtsconnect the 0 terminal of the battery.
Make the proper Input and output cable connecGons for
each unit
Connect the wlrlng harness cables In the following order.
ground, ignition.
Connect the wiring harness connector to the unit.
Install the unit In your car.
Reconnect the @ terminal of the battery.
Press the reset button. (See p. 3)
) AWARNING
1
*This video unit is set for rear passenger use only.
Use of this video unit in any front seat and/or
where it may be visible to the driver may be
illegal in some states and may cause driver
distraction
and accident which could injure or kill
you.
*This
product
IS intended
for use with 12V DC
negative
ground power only. Do not connect
It to
any other power supply
*To prevent
shorting,
disconnect
the battery
cable
from the negative
terminal
of the battery
during
Installation.
l
Be sure to firmly stabilize
this product.
Do not install
it in a location
which
ib not stable.
l
Follow the installation
and wiring procedures
described
in this manual.
Improper
wiring or
modified lnstallatlon can not only result in
malfunction or damage to the unit but may also
result In an accident.
l
Do not install the unit in the following
locations.
*A location which Interferes with the operation
of the air bag system.
*A location which is not made of plastic.
+ lnstalllng on leather, wood or cloth may damage
the surface.
*A location subject to drrect sunlight, subject to the
air front the air conditioner, or subject to moisture
or high temperature.
*This
may cause defqrmatlon
of the monitor
unit.
l
Be sure to use the supplied screws for
installation.
Using screws longer than those supplied may
destroy parts inside the unit causing it to smoke.
Using screws shorter than those supplied may
cause
the unit to come looks from the installation
bracket.
l
If you are not going to install the unit using the
supplied
monitor
stand, be sure to use a
commercially available monitor stand. (Mounting
holes for such a stand are located on the bottom of
the monitor unit.)
l
If your car's ignition
does not come with an ACC
position, connect the ignition cables to a power
source that can be turned on and off with the
ignition key. If you connect the ignition wire to a
power source that receives a constant voltage
supply,
as with battery
cables, the battery
may die.
l
If the fuse blows, first make sure that the cables
have not caused a short circuit, then replace the old
fuse
with one with the same rating.
l
Do not let unconnected cables or terminals touch
metal on the car or anything else conducting
electricity.
To prevent
short circuits
do not remove
the caps from unused terminals or from the ends of
the
unconnected
cables.
*After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
l
Insulate unconnected wires with vinyl tape or other
similar material.
*Thoroughly wipe away and dust or grease from the
Installation
location
using a cloth which
has been
soaked in a neutral cleaning agent and wrung out.
Attach the stand after allowing the installation
location
to drv.
Advertisement
Table of Contents
